Planet FPS-1011 Uživatelský manuál

USB 2.0 GDI Printer ServerFPS-1011Quick Installation Guide

1010. Please set the network setting for the Print Server Manually. By default, the network settings are as follow. IP Address: 192.168.0

1111. Please click “Install Printer” to start the installation.General PrinterNotePlease check with your dealer about the printer type and b

122. The “Install Printer” page is for you to search for the printer drivers. If you want to manually designated the le path of the dri

134. After the drivers are installed completely. Your printer has been found with the Print Server to your computer. Please click “Pri

14GDI/Host-based PrinterFollowing is the installation procedures for “GDI/Host-based Printer” installation.1. Select the “GDI/Host-based Printer” and

15cable, you can click “Connect”.4. The system starts to connect the printer that connected on print server and automatically search and i

165. You will see some prompt messages in the system tray. If there is driver needed you to manually install. In the “Found New Hardware Wizard”, plea

177. Select the correct driver and click “Next”.8. After the driver is installed, click “Finish”.

189. After the driver installed completely (no more prompt message). Your GDI printer has been found with the Print Server to your computer.

1911. Congratulations, the printer is installed successfully. The installed printer will be added to the “Printers & Faxes” in the Windows

Table of CententsPackage Content ... 3Physical Installation

20Further CongurationIf you want to congure more detail settings of FPS-1011, please refer to user’s manual in the CD disk.

This Quick Installation Guide contains brief instructions for the following environments:● Windows 95/98/Me/NT/2000/XP/Sever 2003● Macintosh

4Physical Installation1. Make sure the power is OFF then connect printer to the Print Server’s printer port.2. Connect the LAN cable to t

5Print Server SetupIn the following situation, you do not need to congure the Print Server. Just follow the procedures on section “Administrator

6Administrator PC Setup>> WindowsInstall Print Server Driver1. Insert Drivers and User’s Manual CD into the CD-ROM drive to initiate

74. The system starts installing the Print Server Utilities5. The utilities are all installed. Please click “Finish” to go to next step.

86. The Setup Wizard will be executed, it will guide you to congure the print server and install the printer with the print server to you computer. P

98. Please enter the “Password” of the Print Server you have selected to login the Print Server for more settings. The default “Us