Planet PL-701 Uživatelský manuál

25 500Mbps Powerline Ethernet Bridge PL-701

Chapter 2: Installing 2.1 Overview The installation of 500M Ethernet Bridge will only take minutes. No need to set up long wires through out the hous

Please take a moment to read the license agreement now. If you accept the terms below, click ”I Agree”. Then “Next“. Otherwise click” Cancel”. Thi

Please click on ‘Next’ to confirm the installation. Powerline Utility is being installed, and please waits for installation. 12

This screen shows that the installation was completed successfully. Click on Close to exit the wizard. 13

Chapter 3: Configuration 3.1 Overview The PL-701 uses 128-bit AES encryption to block outside access. The key is set by using the Configuration Util

Note If you do not see ANY unit in the device status but the Powerline device does exist, try to unplug all devices and plug them back. Meanwhile,

Note If there are units in the home network, but nothing displays in this Network scan, try to unplug all devices, and plug them back (Only do this

3.3 Privacy  Setting Up Security on a Local Powerline device The Privacy tab will allow you to change the Network Password to the unit that is cu

 Setting Up Security on a Network Powerline device The Privacy Tab will allow users to use one primary computer to control the Network Password

Note The DEK is unique for EACH Pow erline device. To use this you will need to input the DEK for each unit. 19

Copyright Copyright (C) 2011 PLANET Technology Corp. All rights reserved. The products and programs described in this User’s Manual are licensed prod

3.4 Diagnostics The Diagnostics screen shows system information and a history of all devices seen. Diagnostics Screen The upper panel shows technic

The lower panel contains a history of all remote devices. Devices are shown here regardless of whether or not they are on the same logical network. 

 Use random value of security network (Network AB) 1. Press the security button on Powerline (a) more than 10 seconds until all LEDs off. 2. Pr

233.6 Reset Button This section describes how to use Reset button, this button can be used to clear ALL data and restore ALL settings to the factory

Appendix A Specifications Chipset Atheros AR7400 Protocol Compliant with HomePlug AV 1.1 Co-existing with existing HomePlug 1.0 System Support Windo

CE mark Warning The is a class B device, In a domestic environment, this product may cause radio interference, in which case the user may be required

Table of Content CHAPTER 1: INTRODUCTION ... 5 1.1 OVERVIEW...

Chapter 1: Introduction 1.1 Overview Thank you for purchasing PLANET 500M Powerline Ethernet Bridge. With Planet Powerline communication products, you

1.3 Specification Model PL-701 Standard HomePlug AV IEEE 1901 IEEE 802.3 10Base-T IEEE 802.3u 100Base-TX IEEE 802.3ab 1000Base-T Ports One RJ-45 port

Outlook LED Definition LED Color Behavior Description Green On Power is on Green Blink  System enters the power save mode.  System is

LED Color Behavior Description Green/Red On The device has connected to the power line network. The Data LED color will vary according to the physi

1.6 Wire Diagram 9