Planet ICA-310 Uživatelský manuál Strana 1

User's Manual FSD-804P 8-Port 10/100Mbps with 4-Port PoE Fast Ethernet Switch - 1 -

- 10 - 2.7 Product Application 2.7.1 Connecting end node or switch 1. Place the FSD-804P on a smooth surface or fasten the mounting brackets pur

- 11 - 2.7.2 Department/ Workgroup PoE Switch: Providing up to 4 PoE, in-line power interfaces, the Switch can easily build a power central-contr

- 12 - 2.8 Power over Ethernet Powered Device 3~5 watts Voice over IP phones Enterprise can install POE VoIP Phone, ATA and other Ethernet/non-

- 13 - 3. SWITCH OPERATION 3.1 Address Table The Switch is implemented with an address table. This address table composed of many entries. Each en

- 14 - 4. POWER OVER ETHERNET OVERVIEW What is PoE? Based on the global standard IEEE 802.3af, PoE is a technology for wired Ethernet, the most wi

- 15 - The data pairs are used. Since Ethernet pairs are transformer coupled at each end, it is possible to apply DC power to the center tap of th

- 16 - 5. THE POE PROVISION PROCESS While adding PoE support to networked devices is relatively painless, it should be realized that power cannot

- 17 - 5.3 Start-up Once line detection and optional classification stages are completed, the PSE must switch from low voltage to its full voltage

- 18 - 6.TROUBLESHOOTING This chapter contains information to help you solve problems. If the Switch is not functioning properly, make sure the Et

- 19 - APPENDIX A NETWORKING CONNECTION A.1 DATA OUT PoE Switch RJ-45 Port Pin Assignments (Port 1 to Port-4) PIN NO RJ-45 SIGNAL ASSIGNMENT1 •

- 2 - Trademarks Copyright © PLANET Technology Corp. 2008. Contents subject to revision without prior notice. PLANET is a registered trademark of

- 20 - There are 8 wires on a standard UTP/STP cable and each wire is color-coded. The following shows the pin allocation and color of straight c

- 21 - APPENDIX B B.1 Power over Ethernet Compatibility test No. PDs PoE Output Note 1 [PLANET POE-151S-12V] + [PLANET ICA-500] 9.6W 2 [P

- 3 - TABLE OF CONTENTS 1. INTRODUCTION...

- 4 - 1. INTRODUCTION 1.1 Checklist Check the contents of your package for following parts:  FSD-804P x1  User's manual CD x1  Power co

- 5 - 1.4 Specification Model FSD-804P Hardware Specification Network Connector 8-Port RJ-45 for 10/100Base-TX PoE Inject Port 4-Port with PoE

- 6 - 2. HARDWARE DESCRIPTION This product provides two different running speeds – 10Mbps, 100Mbps in the same switch and automatically distinguis

- 7 - LNK/ACT Green Lit: indicate the link through that port is successfully established. Blinks to indicate that the Switch is actively sending

- 8 - 2.5 Desktop Installation To install the Switch on desktop, simply follow the next steps: Step1: Attach the rubber feet to the recessed area

- 9 - 2.6 Rack Mounting To install the Switch in a 10-inch standard rack, follow the instructions described below. Step1: Place your Fast Etherne